The key points should be paid attention to after the installation of the clean fast door

The debugging and acceptance of the clean fast door is the last step after the installation of the door body. Whether the door body can be successfully accepted is related to whether the door body meets the requirements and can operate normally. The following are the main key points required for debugging and acceptance of the fast door.

When commissioning and accepting clean fast doors, the following key points need to be paid attention to:

Open and close the door repeatedly, and observe whether the door is accurately stopped at the upper and lower limits.

Verify that the curtain naturally touches the ground, if not, it needs to be re-adjusted.

In the process of opening or closing the door, press the emergency stop button and observe whether the door stops running immediately.

Ensure that the emergency stop button is working properly to prevent potential safety risks.

Simulate the entry and exit of actual people or vehicles to test whether the door can automatically open when a person or vehicle approaches.

Ensure that the door can sensitively sense the people and things that need to enter and exit, and make the corresponding opening response in time to improve the convenience of passage.

Simulation in the closing process of the door, the personnel through to observe whether the infrared photoelectric emergency reaction, so that the door body stop running.

If the door body fails to stop in an emergency, it needs to be re-debugged.

When performing these clean fast door commissioning and acceptance steps, it is necessary to ensure that each function operates normally and meets safety standards. This can be comprehensively tested by simulating different scenarios and emergency situations to ensure that the fast shutter door can operate safely and reliably in actual use.